Mastercam – Cape Town Office

Date/Time
Date(s) - 25/11/2019 - 29/11/2019
8:00 am - 4:00 pm

Location
Cape Town Office

Categories


MASTERCAM ESSENTIALS

User face Introduction and wireframe creation and toolpaths.
Contour
Drilling
2D HS Dynamic Mill dynamic facing
2D HS Dynamic contour
Pocket
Pocket re-machining

SURFACE CREATION
From Solid
Flat boundary loft
Extrude
Sweep
Revolve
Draft
Net offset

SOLID CREATION
Extrude, Revolve, Loft Sweep
From Surfaces
(MUST COMPLETE MASTERCAM ESSENTIALS)

MASTERCAM ADVANCED
Plane Creation
3D Wire frame creation
Dynamic Optirough
Pocket
Project Parallel
Plunge
Multi Surface
Area Rough waterline
Hybrid
Contour
Flowline
Spiral
Radial

LATHE
Stock and Chuck Setup
Wire Frame Creation
Generating Toolpaths
Roughing, Finish, Drill
Face, Cutoff groove
Dynamic Roughing
Threading
Canned Rough

Finish Groove at an angle
ID Rough
Finish and Groove Toolpaths
Thread toolpath and stock flip

Mastercam Training and which products is done on witch days

Mastercam Mill and Mill 3D 1-5 days
Mastercam Mill entry 1-3 Days (Monday, Tuesday and Wednesday)
Mastercam Lathe entry and Lathe 1-3 Days (Monday, Tuesday and Friday)
Mastercam Refresher course and upgrade from earlier versions 1-2 Days (Monday and Tuesday)

BACK TO CALENDARBOOK TRAINING